Corrects if I'm wrong, but this code will arbitrarily (but consistently) show either the bmodel face or the world face, depending on facing angle, right? And there's a certain weird angle that will still have z-fighting?
(Not knocking it, seems like a worthwhile hack)
Brush model Z-Fighting Fix
Moderator: InsideQC Admins
19 posts
• Page 1 of 2 • 1, 2
Brush model Z-Fighting Fix
by mh » Mon Dec 22, 2008 5:54 pm
-
mh - Posts: 2292
- Joined: Sat Jan 12, 2008 1:38 am
by Team Xlink » Fri Oct 16, 2009 1:53 pm
- Team Xlink
- Posts: 368
- Joined: Thu Jun 25, 2009 4:45 am
- Location: Michigan
by revelator » Sat Dec 05, 2009 7:48 am
http://en.wikipedia.org/wiki/Z-fighting
in basic its if two surfaces hold the same data in the Z-buffer the image will look like its broken up so to alleviate it you offset part of the data.
or you use a higher resolution Z-buffer.
in basic its if two surfaces hold the same data in the Z-buffer the image will look like its broken up so to alleviate it you offset part of the data.
or you use a higher resolution Z-buffer.
-
revelator - Posts: 2605
- Joined: Thu Jan 24, 2008 12:04 pm
- Location: inside tha debugger
by Team Xlink » Sat Dec 05, 2009 10:12 pm
- Team Xlink
- Posts: 368
- Joined: Thu Jun 25, 2009 4:45 am
- Location: Michigan
19 posts
• Page 1 of 2 • 1, 2
Return to Programming Tutorials
Who is online
Users browsing this forum: No registered users and 2 guests